Why the concrete crumbles (part 1)

Carbonation and chlorides by the sea: why the steel inside the concrete rusts and why painting over it solves nothing.

Length 2:14 min
Subtitles are burned into the picture.Watch on YouTube

Chapters

Transcript

Why the concrete crumbles · Part 1

A house by the sea. Sun, wind and salt. Lovely to live in – and hard on concrete. Why does it crumble?

Reinforced concrete and its protection

Columns and beams are reinforced concrete: the concrete mainly carries compression, the steel inside mainly tension. And the concrete protects the steel – it is highly alkaline, pH above twelve; in it, steel practically does not rust.

Carbonation

But carbon dioxide from the air penetrates the pores and makes the concrete less alkaline – from the outside in, a little deeper every year: carbonation. Once this front reaches the steel, its protection is lost.

Chlorides

By the sea, salt comes into play. Chlorides from the sea air migrate into the concrete – especially fast through cracks, and where the concrete cover is thin, they soon reach the steel. They break through the protective layer even at high pH, locally and deeply: pitting corrosion. This corrosion is particularly aggressive.

Rust needs space

Rust needs space: up to six times the volume of the steel it replaces. This pressure bursts the concrete from within. First cracks, then pieces spall off, the steel lies exposed – and keeps losing cross-section.

Plastering over does not help

Just plaster over it? Then the rust keeps going under the new layer, and after a few years everything is open again.

The damage is inside – you cannot see it, you have to measure it. Part two shows how to do it right. Know first, then build.

Frequently asked questions

Why does steel not normally rust inside concrete?

The concrete protects the steel: it is highly alkaline, with a pH above twelve, and in it steel practically does not rust.

What is carbonation?

Carbon dioxide from the air penetrates the pores and makes the concrete less alkaline, from the outside in, a little deeper every year. Once this front reaches the steel, its protection is lost.

Why is concrete by the sea particularly at risk?

Chlorides from the sea air migrate into the concrete, especially fast through cracks and where the concrete cover is thin. They break through the protective layer even at high pH and cause pitting corrosion, which is particularly aggressive.

Why do pieces of concrete spall off?

Rust needs up to six times the volume of the steel it replaces. This pressure bursts the concrete from within: first cracks, then pieces spall off, the steel lies exposed and keeps losing cross-section.

Is it enough to plaster over the damage?

No. The rust keeps going under the new layer, and after a few years everything is open again. The damage is inside – it has to be measured.

Sources and standards

Laws and regulations linked to the official text (BOE, BOC, codigotecnico.org, INSST); standards cited by number and title only.
Notice: The videos and documents on this page are general technical information on the state of the art. They do not refer to any particular building, construction project or owners’ association; the examples are typified. They replace neither an inspection on site nor the assessment by the competent licensed technicians (dirección facultativa) and do not constitute legal advice. The official standards and legal texts in their current version prevail. Tierra & Madera does not provide services reserved in Spain to licensed technicians.
Made with AI assistance (including the voice and the translation). Content checked by Tierra y Madera, which is responsible for it. © 2026 Frank Thomaschewski / Tierra & Madera · Drawings, diagrams and texts are original works · Fonts under SIL Open Font License · All rights reserved; sharing by link expressly permitted. As of November 2026.